Balloon arch DIY is a fun project to make for children or adults. It can be made with other people to make it more exciting. When this balloon arch is made, there are a few tips that must be kept in mind in order to avoid blowing the arch and ruining the design. It is important that the weather conditions are not favorable for making this balloon arch as the sun and rain may spoil the entire setup.
The first balloon arch diy on the list is composed of black and pink balloons, various colored ribbons, a balloon blower, and white cardboard. To begin, make a 24 inch inside of the pink and purple ribbons using the string and adding a knot at its end. Slip the ends of the strings over the center of the rubber bands and secure it to the wooden board with the large knot. Then make a series of different sizes and colors of balloons in the same way. Once you have them cut into different sizes and then slip them over each other, this will form the arch.
When it comes to learning how to make a balloon arch DIY, one must remember that one has to start from the outside of the arches and work inwards. One needs to know that you need to use glue for this project. Glue the pink balloons to the sides of the large white cardboard that is placed inside a large clear plastic bag. For the large black balloon arch, it is best to use a thick piece of cardboard for this part. Once you have it in place, start gluing the ribbons on one side to the board and then onto the arches. Once they are attached, the next step is to attach the balloon pumps and the ends to the board by sewing them together.
The next step of this how to make a balloon arch DIY project involves attaching the eyelets to the ends of the pink balloons. The easiest way to do this is by sewing them onto the boards as you would attach any other kind of ribbon. This is done in a similar manner to how you attach any other ribbon or other decorative pieces. After attaching them, you need to put some extra glue on the eyelets to hold them in place. Repeat the same procedure for the remaining pink balloons.
The next step is to add some wear to the edge of the board. There is an optional wire mesh that can be used instead of rebar. Since the PVC pipe will be the support for the arch, it is important that it is positioned so that you are not bending it when using the DIY balloon arch stand. For safety, you should position the pipe in a place where it is not in direct sunlight. The pipe should also be placed a bit further away from any objects so you can avoid getting pinched when you pull the arch.
Once you have attached all of the PVC pipes and rebar to the board, you should leave it until it is completely set. You can use a level to ensure that it is straight. You can then attach the final touches to your DIY balloon arch way by cutting out some small holes in the sides using a hot glue gun. This should be done to accommodate the bulbs that will be used in the lighting fixtures as well as any other additional decorations that you plan on putting on the structure.
The final step is to tie one end of the fishing line to the top of one of the command hooks. The other end should also be tied to a clapper that hangs from the ceiling. You can use a combination of both the clappers and fishing line to get more balloons to fill the balloon arch. Be sure to secure these command hooks into place with a strong anchor. If you want to test how to make a balloon arch, you should hang one or two balloons off of one hook and see how high it can rise.
When everything is in place and the weather is good for setting up, you should light up your inflatable and wait for the balloon arch to be completed. You will notice that it rises quite a bit. Once it is fully inflated, you should be able to launch it straight up into the air. When this is done, you should be ready to have some great fun in the garden. Just make sure that you do not overfill it because you do not want it to collapse!